中 文   |   English
 
 
 
Product Categories
 
Hydraulic Curing Press
Column tie rod
Frame
 
     
 
Mechanical Curing Press
PCR
TBS
OTR
 
     
  Hybrid Curing Press  
     
  Bladder Curing Press  
     
 
PCI
R&L Independent control
R&L common control
Single cavity two positions
 
     
  Mold Preheater  
     
  Autoclave  
     
   
 
Contact us
Email:sinoarp@sinoarp.com
Tel: +86-0512-62812532
Fax: +86-0512-62812552
 
 
Home > Detailed content
 
Hybrid Curing Press
Hybrid Curing Press

Introduction of the Press Structure:
Mold opening/closing system adopts driving mode of traditional mechanical curing press' motor, reducer, crank gear, side link and beam. In order to lower press height, tilt-back open/close mold system is still adopted. Loader' up/down and in/out motion is realized with air cylinder. Unloader, top/bottom ring of center mechanism and SMO are actuated with oil cylinder. Stop position of top ring is controlled by linear displacement transducer. Only one motor and one pump are needed for HPU oil tank. The structure is simple and easy for operation.
Main Advantages:
Spacer of center mechanism for shaping is unnecessary. Position of top ring can be set directly on HMI, and positioning accuracy is high.
It' easy to control and adjust amount and speed of the force applied.
Hydraulic part and internal pressure part of center mechanism are completely independent from each other. Service life of internal pressure seal ring is prolonged.
Service life of oil cylinder is longer than that of water cylinder, which reduces maintenance frequency.
Model of the press we've produced: 45"and 69"

 
 
Copyright © 2011-2020 SINO-ARP All Rights Reserved.        ICP:08020482